HC006 Genuine Outlet Hose Clamp 20mm to 38mm for Electrolux Appliances, Electrolux Part 4055985230 Drain Hose Clamp

HC006 is a genuine Electrolux outlet hose clamp, also listed under Electrolux number 4055985230. It grips hoses from 20mm to 38mm across, which suits the larger outlet and drain connections on appliances. Use it to secure a drain or outlet hose onto a spigot, pump outlet or fitting where the old clamp has rusted, snapped or lost its grip.

Why a good clamp matters on drain and outlet hoses

Outlet hoses carry waste water under pump pressure, and a tired clamp is one of the most common causes of slow leaks at a joint. Clamps rust in damp cabinets, spring clips lose tension, and screw clamps can strip or crack when overtightened. Signs to look for are water marks or scale around a hose joint, a hose that pulls off easily, drips during the drain stage, or a clamp that no longer closes up evenly. A new clamp costs little compared with water damage to floors and cabinetry.

Part details

• Genuine Electrolux part HC006
• Electrolux number 4055985230
• Clamping range 20mm to 38mm
• For outlet and drain hose connections

Fitting the hose clamp

Turn the appliance off at the wall and shut the water tap before working on any hose. Clean the spigot and the hose end, push the hose fully on, and position the clamp just behind the raised lip of the spigot. Tighten or close it so the hose is gripped evenly without cutting into the rubber. Run a drain cycle and check the joint stays dry.

Questions about this part

What size hose does this clamp fit?

It's listed for a clamping range of 20mm to 38mm. Measure across the outside of the hose where it sits over the spigot. If that measurement falls inside the range, the clamp is the right size for the joint.