H0184000015 Genuine Dryer Drain Pump for Fisher & Paykel, Haier Dryers DH8060P1 DH9060P1 DH8060C1 DH9060C1 HDHP80E1

Genuine part H0184000015 is the drain pump for a group of Fisher & Paykel and Haier dryers that condense moisture out of the load instead of venting it outside. It's listed for the Fisher & Paykel DH8060P1, DH9060P1, DH8060C1 and DH9060C1, along with the Haier HDHP80E1. If your dryer keeps asking for the water container to be emptied when it's nowhere near full, this pump is a likely suspect.

Why a condensing dryer needs a working drain pump

As the dryer runs, moisture pulled from the wet clothes turns back into water and collects in a sump at the base of the machine. The drain pump lifts that water up into the removable container, or out through a drain hose if the dryer is plumbed to a waste. When the pump stops, the sump fills and the dryer usually halts with a full tank warning even though the container is close to empty. A pump that hums but moves no water, a noisy pump, or water pooling under the dryer are other common signs.

Part details

• Genuine part H0184000015
• Drain pump for dryers that collect condensed water
• Listed for Fisher & Paykel DH8060P1, DH9060P1, DH8060C1 and DH9060C1
• Also listed for the Haier HDHP80E1

Before you swap the pump

Unplug the dryer and empty the water container first. Expect a little water to spill as the old pump comes out, so lay down towels. Check the sump and pump inlet for lint, because a clogged filter or blocked hose can mimic a failed pump. Photograph the hose and wiring layout, fit the new pump the same way, then run a short program and confirm water reaches the container.

Questions about this part

My dryer shows a full tank warning but the container is empty. Is it the pump?

Often it is. A failed or blocked pump leaves water sitting in the sump, which sets off the full warning. Clean the lint filters and check the drain path first. If the warning comes back and the pump hums or stays silent, replace it.