H0181800016 Genuine Controller PCB for Haier, Fisher & Paykel Clothes Dryers, Dryer Main Control Board Replacement

H0181800016 is a genuine Haier controller PCB, the electronic board that runs a dryer's programs. We've listed it for Haier and Fisher & Paykel dryers, as other boards in this number range are dryer controls, but there's no model list on file. Check the number printed on the label of your existing board before ordering, since boards that look alike can carry different software.

Dryer not starting or stopping mid cycle? The controller PCB may be at fault

The controller reads your program selection, switches the drum motor and heater, and watches the temperature and moisture sensors to decide when the load is dry. A failed board can leave the dryer completely dead, stuck on one step, stopping halfway through, or heating while the drum sits still. Error codes on the display help narrow it down. Blocked lint filters and venting cause overheating that can look like a board fault, so clear those and check the sensors before replacing the controller.

Part details

• Genuine Haier part H0181800016
• Controller PCB for clothes dryers
• Match the number on your old board label

Fitting the new controller

Unplug the dryer and wait a few minutes before touching the board. Photograph every connector so each plug goes back to the same socket, and handle the new board by its edges. Once it's in, run a short timed cycle and confirm the drum turns and the heater comes on.

Questions about this part

Can I fit H0181800016 if my old board has a different number?

Only if Haier lists this number as the replacement for yours. Controller boards are matched to specific models and software, so one that looks the same can still behave differently. Send your model and the old board number through our parts enquiry form.