H0180200137 Genuine Lint Filter for Fisher & Paykel, Haier Dryers DH8060C1 DH8060P1 DH9060C1 DH9060P1 HDHP80A1 HDHP80E1

Part H0180200137 is the genuine lint filter for a group of Fisher & Paykel and Haier clothes dryers. On the Fisher & Paykel side it's listed for the DH8060C1, DH8060P1, DH9060C1 and DH9060P1. The Haier models are the HDHP80A1 and HDHP80E1. It catches fluff from the airflow before it can reach the inside of the dryer.

Why a damaged dryer lint filter needs replacing

Every load sheds fibres, and the lint filter stops them collecting inside the machine. When the mesh tears, the frame cracks or the filter no longer seats properly, lint slips past and coats the parts behind it. Clothes then take longer to dry, the dryer runs hotter than it should, and in heat pump and condenser designs the heat exchanger can clog with fluff that is hard to clean out. Never run the dryer with the filter missing, as loose lint is also a fire risk. A cheap new filter protects far more expensive parts.

Part details

• Genuine Fisher & Paykel part H0180200137
• Listed for DH8060C1, DH8060P1, DH9060C1 and DH9060P1
• Also suits Haier HDHP80A1 and HDHP80E1

Fitting and looking after the filter

The filter normally lifts straight out, and the new one drops into the same slot. Check it sits fully down and the door closes without catching it. Clear the mesh after every load, and every so often rinse it under warm water and let it dry completely, since fabric softener residue can block the fine mesh even when it looks clean.

Questions about this part

Where is the model number on my dryer?

Look for the rating label, usually around the door opening or on the back panel. If it shows a Fisher & Paykel DH8060 or DH9060 model ending in C1 or P1, or the Haier HDHP80A1 or HDHP80E1, this lint filter is listed for your dryer.