H0120802341 Genuine Thermo Dry Housing with Seal for Fisher & Paykel, Haier Dishwashers, Drying System Housing

H0120802341 is a genuine thermo dry housing for Fisher & Paykel and Haier dishwashers, and it comes with its seal. Thermo dry is the drying setup that helps remove moisture at the end of a cycle, and this housing is part of it. We don't have a model list for this number, so check it against your old housing or the parts list for your dishwasher's model before ordering.

Dishwasher leaking steam or water at the drying housing

Dishwashers create a lot of hot, wet air during the final rinse and dry. The thermo dry housing holds its drying components in place against the tub, and the seal stops water and steam escaping where they shouldn't. A cracked housing or a seal that has gone flat and hard can let steam or drips out into the cabinet or onto the kitchen floor, leave the surrounding cupboards damp, and make drying less effective so dishes come out wetter than usual. Because the seal is supplied, both parts are renewed in one go.

Part details

• Genuine Haier part H0120802341
• Thermo dry housing, seal included
• Suits Fisher & Paykel and Haier dishwashers
• No model list on file

Fitting the thermo dry housing

Switch the dishwasher off at the wall and turn off the tap. Slide the machine out if you need side or rear access. Photograph the old housing in place, including any hoses and wiring, before removing it. Clean the mating surface on the tub so the new seal sits flat and even, and tighten fixings snugly without cracking the plastic. Run a full program and check for steam or drips.

Questions about this part

Is the seal included?

Yes, the description for H0120802341 says the housing comes with its seal. Fit the new seal rather than reusing the old one, as a compressed seal is a common source of leaks around this area.