H0120600060 Genuine Hinge O-Ring for Haier, Fisher & Paykel Dishwashers, Replacement Rubber Seal Ring, Haier 0120600060

Part H0120600060 is a genuine Haier O-ring listed for the hinge in Haier and Fisher & Paykel dishwashers. O-rings are small, but a perished or missing one can let water seep out or leave a joint sloppy. Small rings like this are easily confused with others of a similar size, so compare the number with your parts list or the old ring before ordering.

What a perished hinge O-ring can cause

An O-ring is a round rubber seal that sits in a groove and is squeezed between two parts to close the gap. Heat, detergent and years of door movement slowly harden the rubber, which then flattens or cracks and stops filling that gap. Where the ring seals a joint that water can reach, you may notice a slow drip or damp patch near a lower corner of the door. Where it cushions the hinge, the joint can become loose, noisy or stiff. Replacing the ring is quick once the hinge area is exposed.

Part details

• Genuine Haier part number H0120600060
• Haier number 0120600060
• O-ring for the dishwasher hinge

Replacing the O-ring

Switch the dishwasher off at the wall before taking any panels off. Expose the hinge area following your service manual, and note how the old ring sits before removing it. Clean the groove, fit the new O-ring without stretching or twisting it, and reassemble. Open and close the door a few times, then check for leaks after the next wash.

Questions about this part

How do I check this O-ring suits my dishwasher?

Read the model number off the label on the inner edge of the door, then send it through the parts enquiry form. We will check it against H0120600060 before you order.