H0120104971P Genuine Dishwasher Door Spring Pack of 2 for Fisher & Paykel, Haier Dishwashers, Door Balance Spring Pair

A packet of two genuine door springs, part number H0120104971P, for Fisher & Paykel and Haier dishwashers. These springs balance the weight of the door so it opens smoothly and stays where you leave it. The pack lets you replace both sides at once, which is the sensible way to do it, since the second spring is usually just as tired as the one that broke. The P on the end of the number marks the two pack.

Dishwasher door dropping open? Check the springs

Each side of the door has a spring that takes the weight as the door lowers, connected to the hinge arm by a cord or link on most models. Springs stretch and lose tension over years of use, and they can snap without warning. Signs to look for are a door that falls open with a thud, one that won't stay half open, a door that springs shut too hard, a twanging or creaking noise from the base, or a spring hanging loose under the tub. Fresh springs also take strain off the hinges.

Part details

• Genuine part H0120104971P
• Packet of 2 dishwasher door springs
• Replace both sides together for an evenly balanced door
• For Fisher & Paykel and Haier dishwashers, check your part number

Fitting the door springs

Switch off at the wall and turn off the water tap before sliding the dishwasher out of its cavity. On most models the springs sit low on the sides of the tub, so you may need to remove the kickboard or a side panel. Note exactly how the old springs attach, then fit the new pair the same way. Check the door holds halfway open before you push the dishwasher back in.

Questions about this part

Do I need to replace both springs?

It's strongly recommended. Two springs share the door's weight, so a new spring paired with an old stretched one leaves the door pulling to one side and wears the weaker spring faster. That's why this part comes as a pack of two.