H0030813627Q Genuine Lid Assembly for Haier Top Load Washing Machines HWT10ANB1

A cracked or warped lid on a Haier HWT10ANB1 top loader can stop it spinning altogether. H0030813627Q is the genuine Haier lid assembly for that model. If your lid is cracked, a hinge point has snapped, or it won't sit flat and close properly, swapping in the complete assembly restores the look and lets the lid lock engage as it should.

Top loader stopping with a lid fault?

The lid does more than keep the washing in. On a top loader, closing it engages the lid lock or switch, which tells the controller it's safe to agitate and spin. A lid that's warped, cracked or loose at the hinges may not press the lock fully, so the machine stops before spinning, keeps flashing a lid fault, or won't start at all. A broken lid can also pinch fingers and let water splash out during the wash. If the lid looks fine but the machine still reports a lid fault, test the lid lock itself before replacing the lid.

Part details

• Genuine Haier part H0030813627Q
• Complete top loader lid assembly
• Listed for the HWT10ANB1
• Replaces a cracked, warped or broken lid

Fitting the new lid

Unplug the washer at the wall first. Lid assemblies are usually held by hinge fixings at the back of the top panel, so check how yours is attached and take a photo before undoing anything. Fit the new lid, tighten the fixings evenly, and make sure it closes square and engages the lock. Run a short spin to confirm the machine accepts the lid as closed.

Questions about this part

Does it fit other HWT models?

This lid assembly is listed for the HWT10ANB1. Other HWT models may use a different lid, so check the model on your machine's label, often on the back or under the lid, and send it to us if yours is different.