H0030301012 Genuine Tub to Pump Hose for Haier, Fisher & Paykel Washing Machines, Internal Drain Hose from Outer Tub

H0030301012 is the genuine Haier hose that runs from the bottom of the outer tub to the drain pump, used in Haier and Fisher & Paykel washing machines. Every drop of water leaving the tub passes through it. We don't hold a list of compatible models for this hose, so compare it with the number on your old hose or send your washer model through the parts enquiry form.

Washer leaking underneath or not draining? Check the tub to pump hose

When the wash or rinse finishes, water flows out of the outer tub, down this hose and into the drain pump. Over time the rubber can perish and split, often at the bends or where the clamps grip it, and you'll find water on the floor every time the machine empties. The hose is also a common trap for lint, hair ties, coins and small socks. A partial blockage gives slow draining and clothes left soaking wet after the spin, while a full blockage leaves water sitting in the drum and may bring up a drain error.

Part details

• Genuine Haier part H0030301012
• Internal hose from the outer tub to the drain pump
• Suits Haier and Fisher & Paykel washing machines
• Confirm fit by the number on your old hose

Swapping the hose

Switch off at the wall and turn off the taps. Drain as much water as you can by lowering the outlet hose into a bucket, then lay towels around the machine. Note which way the old hose is turned and where each clamp sits before you remove it. Check the clamps grip firmly on the new hose and that it isn't twisted or kinked, then run a rinse and spin while you watch for drips.

Questions about this part

Can I clear the old hose instead of replacing it?

If it's only blocked, clearing it may be enough. If the rubber is cracked, hard or split, replace it. A perished hose usually starts leaking again soon after it's disturbed.