H0020600081A Genuine Door Seal Clamp for Fisher & Paykel, Haier Front Load Washing Machines WH1060P4 WH9060P4 WD8560F1 HWF80BW1 H0020600081

Part H0020600081A is the genuine clamp that holds the door seal, or bellows, in place on Fisher & Paykel and Haier front loaders. Some listings drop the final letter and show it as H0020600081. It is listed for the Fisher & Paykel WH1060P4 and WH9060P4, the WD8560F1 and the Haier HWF80BW1. A loose or stretched clamp is a common reason for water escaping around the door.

Water leaking from the front of your Fisher & Paykel washer?

The door seal is a flexible rubber boot joining the front of the cabinet to the outer tub, and clamps hold its edges tight so water cannot get past. If a clamp stretches, loses tension or slips out of its groove, the seal can lift away and let water run down the front of the machine during the wash or spin. You might also see the seal hanging loose at the door opening or sitting unevenly. Clamps come off whenever a seal is replaced, and a tired one is worth renewing at the same time.

Part details

• Genuine part H0020600081A
• Also listed as H0020600081
• Clamp for the door seal, also called the bellows
• Listed for Fisher & Paykel and Haier front load washers

Refitting the seal clamp

Unplug the washer and make sure the drum is empty. Note where the clamp's spring or join sits before you lever it off, as the new one should go back in the same position. Seat the seal lip evenly in its groove all the way round, then stretch the clamp over it and work it into the groove with your thumbs or a blunt plastic tool. Run a short rinse and check for drips at the front.

Questions about this part

Is this the clamp for the inner or outer edge of the seal?

The listing describes it as the door bellows clamp without naming the position. Compare it with your old clamp or your machine's parts list, and send your model through the parts enquiry form if you are unsure which one you need.