AT53APB01 Genuine Push Button for Glen Dimplex Group Rangehoods, Replacement Rangehood Control Button

Part AT53APB01 is a genuine push button made for rangehoods sold by the Glen Dimplex group in Australia. Buttons like this sit on the front control strip and are what you press to run the fan or turn on the light. Our record describes it only as a push button, with no model list attached, so the surest check is the AT53APB01 number on your parts list or a side by side look at the old button.

Rangehood button stuck, cracked or not responding?

Push buttons get pressed every time the hood is used, often with greasy or damp fingers. Over time the plastic cap can split, the spring action can go soft, or grease can build up until the button sticks down or won't pop back. Some wear their printed symbol off, others snap a locating leg and sink into the panel. If the button moves freely but nothing happens when you press it, the fault may sit behind it on the switch or control board, so check that before ordering.

Part details

• Genuine Glen Dimplex group part AT53APB01
• Push button for rangehood controls
• No model list on file, match the part number or the old button

Fitting a new push button

Turn the rangehood off and isolate it at the wall or the circuit breaker before taking the control panel apart. Remove the filters to reach the fixings, then lower or unclip the control housing. Note which way the old button faces and how it locates, fit the new one the same way, and press it a few times to check it springs back before you put everything together.

Questions about this part

Is this a single button or a full set?

Our record lists AT53APB01 as a push button in the singular and doesn't spell out what is supplied. Compare the photo with your control panel, or send your rangehood model through the parts enquiry form and we'll confirm what you get.