8588071029025 Genuine Reed Switch Wiring Harness for Electrolux Group Appliances, Reed Sensor Lead, Also 807102902

A genuine Electrolux group wiring harness for a reed switch, part 8588071029025 is also listed under the 9 digit number 807102902. It's the lead that links a magnetic reed sensor to the appliance's control board. We don't have the appliance type or a model list recorded for it, so match the number on your parts list or on the tag of the old harness before ordering.

When a reed switch harness needs replacing

Reed switches are used to sense position, such as a closed lid or door, or a float reaching a set level. The harness carries the signal back to the controls, so a fault in it looks just like a failed sensor. Watch for errors that come and go, a machine that won't start or stops mid-cycle, or a fault that changes when you move the wiring. Rodent damage, chafing on sharp edges, water getting into the connectors and corroded pins are the usual culprits.

Part details

• Genuine Electrolux group part 8588071029025
• Also numbered 807102902
• Wiring harness for a reed switch
• Appliance and models not on file, order by number

Fitting a wiring harness

Disconnect the appliance from power before opening any panel. Follow the old harness from end to end and photograph each plug and clip point. Fit the new one along the same route, seating every connector until it latches, and refit the cable ties or clips that keep it away from moving or hot parts. Test the appliance through a full cycle before putting it back into service.

Questions about this part

How do I know it's the harness and not the reed switch?

Check continuity through each wire of the harness with a multimeter while flexing it. If the harness reads fine, test the reed switch by bringing a magnet near it. Look for corrosion or a loose pin in the plugs as well.