8581192402114 Genuine Drain Hose 1750mm 45 Degree Cuff 22mm for Simpson, Westinghouse Washing Machines SWT9043 SWT8043 SWT6541 WWT8040

Part 8581192402114 is a genuine 1750mm drain hose with a 45 degree cuff sized at 22mm, made for Simpson and Westinghouse top load washers. It's also listed as 119240211. Models on file include the Simpson SWT9043, SWT8043 and SWT1043, the SWT6541 and SWT5541, and the Westinghouse WWT8040, WWT6040 and WWT1020A.

Washing machine leaking from the drain hose

The drain hose carries water from the pump out to your laundry tub or standpipe at the end of each wash and during spin. Hoses get stepped on, kinked behind the machine, or split where they hook over the tub, and the rubber hardens with age. A cracked hose usually shows up as water on the floor only while the machine is draining. A kinked or crushed hose slows the drain, which can leave water in the bowl or stop the spin from starting. If the cuff has split, water will drip from that joint.

Part details

• Genuine Electrolux group part 8581192402114
• Also listed as 119240211
• Length 1750mm
• 45 degree cuff, 22mm
• Listed for Simpson SWT and Westinghouse WWT top loaders

Fitting the new drain hose

Unplug the washer and turn off the taps. Lower the old hose into a bucket to drain any water left inside, then release the hose clip at the cuff, if one is fitted, and pull the hose off. Push the new cuff fully onto its spigot, refit the clip and route the hose without kinks. Hook the outlet end securely over the tub or into the standpipe and run a drain cycle to check for leaks.

Questions about this part

What if 1750mm isn't long enough?

A longer 2370mm hose, part 1240881704, is listed as a usable alternative for these machines. Avoid joining hoses where you can, as every joint is another place for a leak, and keep the outlet at the height the installation guide recommends.