791097 Genuine Hose Clamp 20 to 32mm for Fisher & Paykel Appliances, Clamp for Securing Hoses on 20-32mm Spigots

Part 791097 is a genuine Fisher & Paykel hose clamp that closes over a 20 to 32mm range. It holds a hose firmly on its spigot so the joint doesn't seep or blow off under pressure. Measure the outside of the hose where it sits over the spigot, and make sure that size falls inside the 20 to 32mm range before ordering.

Leaking hose joint? A new clamp is often the fix

Hose clamps hold rubber and plastic hoses tight against their spigots on pumps, sumps, valves and outlets. Over time a clamp can rust, stretch, lose tension or be damaged when a hose is removed for cleaning or repairs. The result is a slow drip at the joint, water pooling under the appliance, or a hose that pulls free when the appliance pumps out. Reusing an old, distorted clamp is a common cause of leaks after a repair. Replace the clamp and check the hose end isn't split or hardened.

Part details

• Genuine Fisher & Paykel part 791097
• Hose clamp
• Clamping range 20 to 32mm
• For securing hoses on Fisher & Paykel appliances

Fitting the clamp

Turn the appliance off at the wall and shut the water tap if the hose carries supply water. Slide the clamp over the hose before pushing the hose fully onto its spigot, then position the clamp just behind the spigot's raised lip. Secure it so the hose is held firmly all round, without crushing or cutting into it. Run the appliance and check the joint for drips.

Questions about this part

How do I measure for a hose clamp?

Measure the outside diameter of the hose while it's pushed onto the spigot, as that's what the clamp closes around. This clamp suits sizes from 20 to 32mm. Larger hoses need a bigger clamp.