758973779 Genuine Dishwasher Drain Hose 2m for Smeg Dishwashers DWA147X DWA157X DWA214S DWA315X DWAI214X DWAU149X DWA6214W DWAU315X1

758973779 is the genuine 2m drain hose for Smeg dishwashers, carrying waste water from the pump out to the sink trap or standpipe. There are 30 models on file, among them the DWA147W and DWA147X, the DWA149W and DWA157X, the DWA214S, DWA314X and DWA315X, and the DWAI214X, DWAU149X, DWAU315X1 and DWA6214W. A split, kinked or perished drain hose can cause leaks or slow draining, and this is the direct replacement.

Smeg dishwasher not draining or leaking under the sink?

When the pump runs, it pushes dirty water up through this hose and into the household drain. A hose that has been crushed behind the dishwasher, chewed by pests or hardened with age will crack or kink. Signs include water left in the bottom of the tub after a cycle, a drain error, gurgling from the sink, or water appearing under the sink cabinet during the pump out. Always check the sink spigot and the dishwasher filter for blockages too.

Part details

• Genuine Smeg part 758973779
• Drain hose, 2m long
• On file for 30 Smeg dishwasher models
• Covers DWA, DWAI, DWAU and DWA6 models

Changing the drain hose

Turn the dishwasher off at the wall, shut the water tap and slide the unit out carefully. Have a towel ready, as the old hose holds water. Disconnect the hose at the pump outlet and the sink spigot, then fit the new one, keeping the high loop at the height the installation manual specifies. Secure both ends with clamps, avoid sharp bends behind the unit and test with a short wash.

Questions about this part

Is 2m long enough for my kitchen?

This hose is 2m long. Measure the run from the back of the dishwasher to your drain connection, allowing for the high loop, before ordering. If it falls short, the installation instructions for your model will say what kind of extension is allowed.