551376P Genuine Single Wall Oven Temperature Module for Fisher & Paykel Wall Ovens, Oven Temperature Control Board Service Part

Single wall ovens from Fisher & Paykel use a temperature module to run the heating, and 551376P is the genuine service replacement for that module. It is listed for single cavity wall ovens rather than double units. Without a model list on file, match the number on your old module, or find the model and serial number on the oven's data label, often visible on the frame when the door is open, and send them to us via the parts enquiry form.

Wall oven not holding temperature?

In an electronic oven, the temperature module reads the oven sensor and switches the elements to hold the heat you've set. It works alongside the user controls and the other electronics. A fault here can leave the oven stone cold, heating well past the setting, cycling erratically or showing an error on the display. Before buying a module, test the sensor and elements, as they fail more often and can produce the same symptoms. Burnt tracks, a swollen component or a scorched relay on the board point to the module itself.

Part details

• Genuine Fisher & Paykel part 551376P
• Temperature module for single wall ovens
• Service replacement module
• Hard-wired appliance, licensed electrician to fit

Fitting the module

Turn the oven off at the switchboard before pulling it from the cabinet, and have a licensed electrician do the work. Photograph every plug and terminal on the old module, and handle the new board by its edges to avoid static damage. Once it is fitted, run the oven through a full heat cycle and confirm it reaches and holds temperature.

Questions about this part

Will it fit a double wall oven?

It is listed for single wall ovens. Double ovens normally use different control parts, so if your oven has two cavities, send us your model number through the parts enquiry form before ordering.