527137 Genuine Drain Hose Kit for Fisher & Paykel DishDrawer Dishwashers DD603 DD603I DD603M DD601V2 DS603 DS603I DS601V2

Fisher & Paykel's genuine drain hose kit 527137 carries waste water from the DishDrawer to your sink plumbing. It's listed for the DD601V2 and DD603 double drawer families and the matching DS601V2 and DS603 single drawers, including the FD, H, I, M and MFD variants. Swap it in when the existing hose is split, kinked beyond saving or perished at the ends.

Dishwasher not draining or leaking under the sink?

After each wash the drain pump pushes dirty water out through this hose to the sink waste or standpipe. Over time a hose can split, harden or get crushed behind the cabinet when the dishwasher is pushed back in. A damaged hose shows up as water pooling inside the cupboard or under the kickboard, a musty smell, or a drawer that holds water in the bottom after the program finishes. A kink or blockage slows draining and can bring up a drain fault. Before ordering, check the hose for splits along its length and clear any food build up at the sink end.

Part details

• Genuine Fisher & Paykel drain hose kit, part 527137
• Listed for DD601V2 and DD603 double DishDrawers
• Also suits DS601V2 and DS603 single drawer models
• Covers FD, H, I, M and MFD variants on file

Fitting the new drain hose

Turn off the power at the wall and the water at the tap, then slide the dishwasher out carefully so you don't strain the other hoses or the cable. Lay a towel down, as the old hose will hold some dirty water. Route the new hose without sharp bends and secure it at the waste outlet. Push the unit back slowly, watching that nothing gets pinched, then run a rinse and check for leaks.

Questions about this part

Do double and single DishDrawers use the same hose?

For the 601V2 and 603 ranges, this kit is listed for both the double DD models and the single DS models. Other DishDrawer series may use a different hose, so confirm your model number before you order.