525460 Genuine Single Drain Spigot Connector for Fisher & Paykel DishDrawer Dishwashers DD60SCX9 DD60DCX9 DD60SDFX7 DD605 DD603 DD90SDFTX2

Part 525460 is the genuine Fisher & Paykel single drain spigot connector for DishDrawer dishwashers. It is the connector used on the drain side of the installation, joining the drain hose to a spigot. There are 90 models on file, from the DD603 and DD605 to DD60 drawers ending in 6, 7, 8 and 9, such as the DD60SCX9 and DD60DCX9, plus DD90 models like the DD90SDFTX2.

Water under the sink after a DishDrawer cycle?

Drain water from a dishwasher is pumped out under pressure, so every joint between the hose and the waste plumbing has to stay tight. A connector that has perished, cracked or stretched over time can leak each time the drawer pumps out, leaving water in the cupboard under the sink or around the base of the cabinet. A loose fit can also let the hose pop off the spigot. If you are moving the dishwasher or re-plumbing the sink waste, a fresh connector is worth fitting while everything is apart.

Part details

• Genuine Fisher & Paykel part 525460
• Single drain spigot connector
• For DishDrawer drain hose connections
• Listed for 90 DishDrawer models

Fitting the connector

Turn the dishwasher off at the wall before working on the drain. Have a bucket and towel ready, as water sitting in the hose will run out. Push the connector fully onto the spigot and the hose, then secure it with a suitable hose clamp. Make sure the hose has no kinks or sags that could hold water, run a cycle and check the joint while the drawer pumps out.

Questions about this part

Is this a single or double connector?

This listing is the single connector. Check how your drain is set up and compare with the old connector before ordering. If you are unsure which suits your installation, send your model and a description of the drain setup through the parts enquiry form.