523649 Genuine DishDrawer Crockery Insert for Fisher & Paykel Dishwashers DD60DCX9 DD60SCX9 DD60DCW9 DD60DCX7 DD60SCW7 DD60SLI9 DD24DUT7

Fisher & Paykel DishDrawer owners can replace a worn plate rack with crockery insert assembly 523649, a genuine F&P part. The insert sits in the drawer and holds plates and bowls upright so the spray reaches both faces. It is listed for the DD60DCX9, DD60SCX9, DD60DCW9 and DD60SLI9, the DD60DCW7, DD60DCX7 and DD60SCW7, and the DD24SUT7 and DD24DUT7.

Plates falling over or tines broken in your DishDrawer?

The crockery insert is the section of rack with rows of tines that stand plates on edge and space them apart. Good spacing lets water from the spray arm reach every surface and drain away cleanly. Over time tines snap or bend, and the clips that hold the insert in the drawer break. Plates then lean into each other, come out with food still on them, rattle during the wash or tip onto the spray arm and stop it turning.

Part details

• Genuine Fisher & Paykel part 523649
• Crockery insert assembly for DishDrawer dishwashers
• Holds plates and bowls upright
• Listed for DD60 and DD24 models on file

Fitting the crockery insert

Open the drawer fully with the dishwasher switched off. Unclip the old insert from the rack, noting which way round it sits and where the clips locate. Press the new insert into the same position until each clip holds, then load a few plates to check the spacing and run the drawer in and out to make sure nothing catches as it closes.

Questions about this part

Where is the model number on a DishDrawer?

On most DishDrawer models the rating label is on the side or front edge of the drawer, visible when it is open. It shows a model such as DD60DCX9 and a serial number. Compare the model with the list here before ordering.