512058P Genuine Flange Display Module for Fisher & Paykel Phase 9 DishDrawer Dishwashers, Drawer Control Panel Display

The display module 512058P is a genuine Fisher & Paykel spare for Phase 9 DishDrawer dishwashers, in the flange style. It's the control and display unit you press to choose a wash and see the drawer's status. Phase 9 drawers usually carry a 9 at the end of the model number, but more than one display style was made for this generation, so match the number on your old module or check your model and product code before ordering.

Signs your DishDrawer display module has failed

The display module is the drawer's user interface. It reads your button presses, shows the selected program and any error codes, and talks to the wash controller that runs the motor, heater and valves. A failing module can leave the panel blank, make buttons slow or unresponsive, show missing segments or lights, or let the drawer lock and beep without starting. Moisture getting into the drawer front is a frequent cause. Because a faulty controller or wiring can give similar symptoms, check those before replacing the display.

Part details

• Genuine Fisher & Paykel part 512058P
• Display module, flange type
• For Phase 9 DishDrawer dishwashers
• Check the number on your old module before ordering

Fitting the display module

Isolate the dishwasher at the wall before touching any electronics. Open the drawer and remove the front panel or trim to reach the display, keeping track of the screws and clips. Handle the new module by its edges and avoid static. Plug in each connector firmly, make sure any seals around the display are seated so water can't get in, then restore power and run a test cycle.

Questions about this part

How do I tell if my DishDrawer is Phase 9?

Check the model number and product code printed on the drawer's rating label. Many Phase 9 models end their model number in 9. Send both codes through the parts enquiry form and we'll confirm whether this display module is the right one.