511 Generic Water Filter Mounting Bracket, Universal Water Filter Part from the Crystal Clear Range for Fixing a Filter Housing in Place

Stock code 511 is a generic water filter mounting bracket from the Crystal Clear range. It gives a filter housing a firm fixing point so it isn't left hanging on its water lines under the sink, behind the fridge or inside a cupboard. No housing size or filter model is on file for this bracket, so compare it with your filter before ordering, or send the filter details through the parts enquiry form.

Why a water filter should be mounted on a bracket

A water filter sits at mains pressure and gets heavy once the cartridge is full of water. Left loose, it can sag, twist its push-fit fittings and slowly work a joint until it starts to weep. A bracket holds the housing still, keeps the inlet and outlet tubes running straight and makes cartridge changes easier because the housing stays put while you swap the cartridge. If your filter is held up with cable ties, sitting on the cupboard floor or hanging from a cracked bracket, a new one tidies the install and takes the strain off the fittings.

Part details

• Stock code 511
• Generic water filter mounting bracket
• From the Crystal Clear water filter range
• No housing size on file, check it against your filter

Fitting the mounting bracket

Turn off the water to the filter and release the pressure before you move it. Hold the bracket in position and mark the fixing holes, leaving clearance below for cartridge changes and room for the tubes to run without tight bends. Use screws that suit the surface, refit the filter, then turn the water back on slowly and check each fitting for drips.

Questions about this part

Will this bracket fit my water filter?

There is no housing diameter or filter model on file for bracket 511. Compare it with your filter or the old bracket, or send the filter brand and model through the parts enquiry form so we can check it before you order.