4055944385 Genuine Dishwasher Inlet Hose 2.5m with Nut and Tail Ends for Electrolux Group Dishwashers

Part 4055944385 is a genuine Electrolux dishwasher inlet hose, 2.5m long, with a nut at one end and a tail at the other. It carries mains water from the tap to the dishwasher's inlet valve. The extra length helps when the tap sits in the next cupboard or the machine has been moved along the bench. Check both end fittings against your old hose before ordering.

Dishwasher leaking or slow to fill with water?

The inlet hose is a simple part, but it's under mains pressure whenever the tap is on. Rubber ages, fittings crack, and hoses get kinked or crushed when a dishwasher is pushed back into its cavity. A failing hose shows up as water on the floor or in the cupboard, a wet base tray that triggers the leak protection on models that have it, or a machine that fills slowly or shows a water supply error. Replace any hose that is bulging, cracked or stiff before it bursts.

Part details

• Genuine Electrolux part 4055944385
• Dishwasher water inlet hose
• 2.5m length
• Nut and tail end fittings

Fitting the inlet hose

Turn the water off at the tap and switch the dishwasher off at the wall. Have a towel and a shallow tray ready, since the old hose will hold some water. Undo the old hose at both ends, check the tap washer is in good condition and fit the new hose without kinks. Tighten the fittings firmly by hand plus a small nip, then turn the tap on and check for drips.

Questions about this part

Is 2.5m long enough for my kitchen?

Measure the path from your tap to the inlet at the back of the dishwasher, allowing the hose to run without sharp bends. Avoid extending a hose with joiners, as every joint adds another possible leak point.