4055710117 Genuine Dishwasher Drain Hose 2m for Westinghouse Dishwashers WSF6606X WSF6606W WSF6606XA WSF6608X WSF6608W WSF67381S WSU67381S

A split or kinked outlet hose is a common cause of water under a dishwasher. Part 4055710117 is the genuine 2m (200cm) drain hose for a group of Westinghouse dishwashers, also listed as 42005936. It suits the WSF6606W and WSF6606X, the WSF6606XA, and the WSF6608W and WSF6608X, along with the WSF67251S, WSF67381S and WSU67381S.

Dishwasher leaking or not draining? Check the drain hose

The drain hose carries waste water from the dishwasher's pump to your sink waste or standpipe. It lives behind the machine and under the sink, where it can be kinked when the dishwasher is pushed back, squashed by stored items, or worn through where it rubs on the cabinet. Hoses also crack with age. A kinked or blocked hose leaves dirty water sitting in the bottom of the tub at the end of a cycle, while a split one leaks under the cabinet, often unnoticed until the floor or kickboard swells. Check the full length for damage and sludge.

Part details

• Genuine Electrolux group part 4055710117
• Alternative number 42005936
• 2m (200cm) drain hose
• Listed for Westinghouse WSF6606 and WSF6608 models plus WSF67251S, WSF67381S and WSU67381S

Replacing the drain hose

Turn the dishwasher off at the wall and shut the water tap. Slide the machine out, put a towel and tray under the pump connection and disconnect the old hose at both ends. Fit the new hose to the pump with its clamp, route it without kinks and keep a high loop under the bench before connecting to the waste. Run a rinse and check both ends for drips.

Questions about this part

Can I extend the drain hose?

Joining extra hose on adds leak points and can make the pump work harder. This hose is 2m long, so measure the run from the dishwasher to your sink waste before ordering, and follow the installation guide for your model if you need more length.