350564 Genuine Aqua Stop Extension Kit 2m Inlet and Drain Hose for Bosch, Siemens, Neff Dishwashers 00350564

Need to install a dishwasher further from the taps or drain? Part 350564 is the genuine BSH extension kit with a 2m Aqua Stop inlet hose and a 2m drain hose. It suits Bosch, Siemens and Neff dishwashers fitted with Aqua Stop, and it's also listed as 00350564, 00571863 and 00462876. Measure the run you need before ordering to make sure 2m is enough.

When you need a dishwasher hose extension

Kitchen renovations, island benches and corner installs often leave the dishwasher further from the taps and waste than the factory hoses can reach. Joining random hoses is risky, especially on the inlet side, where the Aqua Stop system is there to shut off the water if a leak is detected. This kit extends the inlet with a matching Aqua Stop hose and adds a drain extension of the same length. It's also the answer when the original hoses come up short after an appliance has been moved.

Part details

• Genuine BSH part 350564, also 00350564
• Also listed as 00571863 and 00462876
• Aqua Stop inlet hose, 2m
• Drain hose extension, 2m
• For Bosch, Siemens and Neff dishwashers with Aqua Stop

Installing the extension kit

Turn off the water at the tap and switch off at the wall before disconnecting anything. Fit the inlet extension as described in the instructions supplied with the kit, then join the drain extension to the dishwasher's drain hose. Keep both hoses free of kinks and tight bends, and support them so they can't rub. Turn the water on slowly and check every joint for leaks.

Questions about this part

Do I get both hoses in the kit?

Yes. The kit contains an Aqua Stop inlet hose and a drain hose, each 2m long, so both connections can reach further. Check the length you need before ordering by measuring along the route the hoses will actually take behind the cabinets.