140237163013 Genuine O-Ring Seal INSOR 109C02 for Electrolux Group Appliances, Replacement Sealing Ring

Carrying the stock reference INSOR 109C02, part 140237163013 is a genuine Electrolux O-ring seal. O-rings like this sit in a groove between two parts and squeeze tight to stop water, air or gas escaping at the joint. The appliance it belongs to isn't recorded against this number, so the safest way to order is to match 140237163013 to the parts list for your model or to the code on the original packet.

When a worn O-ring causes a leak

An O-ring only seals while it stays round, soft and the right size for its groove. Heat, detergents, cleaning chemicals and age slowly harden the material until it flattens, cracks or shrinks. At that point the joint it was protecting starts to weep, drip or lose pressure, and you might find water pooling under the appliance or a fitting that won't stay tight. Reusing an old O-ring after parts are pulled apart for another repair is a common cause of fresh leaks, so it pays to replace them whenever a joint is opened.

Part details

• Genuine Electrolux part 140237163013
• O-ring seal
• Stock reference INSOR 109C02
• For Electrolux group appliances

Tips for fitting an O-ring

Isolate the appliance from power and turn off any water or gas supply to the part before opening the joint. Clean the groove and mating surface so no old fragments or grit remain. A light smear of a lubricant suited to the seal material helps it seat without twisting. Reassemble, restore the supply and check the joint for leaks. Gas joints must be done by a licensed gas fitter.

Questions about this part

How do I know this is the right O-ring?

Size matters with O-rings, and close enough is not good enough. Look up your appliance's model and product number on its rating plate, then check that 140237163013 appears in its parts list, or send the details through our enquiry form and we'll check.