140194748012 Genuine 200mm Enamelled Spill Bowl for Electrolux Group Electric Cooktops and Cookers, Hotplate Drip Bowl

Part 140194748012 is a genuine Electrolux group spill bowl, enamelled and 200mm in diameter. Spill bowls sit under coil hotplate elements on electric cooktops and cookers, catching boil-overs and reflecting heat back up towards the pan. The catalogue tags it as an NZ part, and a 160mm version is listed separately as 140194749010, so measure your old bowl and check the number before ordering.

Rusty, chipped or stained hotplate spill bowls

Every boil-over and splash lands in the spill bowl, where it gets baked on by the element above. Over the years the enamel chips, rust starts at the edges and the centre hole can corrode, leaving a bowl that's impossible to clean properly. A warped bowl may also stop the element sitting level, and burnt-on residue can smoke or smell every time the hotplate heats up. Fresh bowls make the cooktop easier to keep clean and give the coil a stable, tidy surround.

Part details

• Genuine Electrolux group part 140194748012
• Enamelled spill bowl
• 200mm diameter
• Catalogued as an NZ part
• 160mm version listed as 140194749010

Fitting the spill bowl

Switch the cooktop off at the wall or isolator and let the hotplates cool. On plug-in coil hotplates, lift the element at the front and ease it out of its terminal block without pulling on the wires. Lift out the old bowl, clean the well underneath, drop the new bowl into place and refit the element so it sits level and plugs in fully.

Questions about this part

Will the 200mm bowl fit my hotplate?

Spill bowls are sized to the element above them, so measure across your old bowl. This one is 200mm. For a smaller element, the 160mm enamelled bowl 140194749010 is catalogued separately.