140182722011 Genuine 60cm Thin Cast Trivet Pan Support for Electrolux Group Stainless Steel Gas Cooktops, Cast Pan Support Replacement

140182722011 is a genuine Electrolux group pan support, listed as a thin cast trivet for 60cm stainless steel gas cooktops. It's the grate that sits over the burners and holds your pots and pans. The thin cast style is a specific design, so it may not match a cooktop that uses heavier cast or wire supports. Check this number on your cooktop's parts list before ordering.

Replacing a cracked or worn 60cm cooktop trivet

Cast pan supports take a lot of punishment. They're heated and cooled every time you cook, knocked by heavy pots and scrubbed hard after boil-overs. Eventually the coating can chip and rust can form, a finger can crack or snap off, or the trivet can warp so pans sit on a slant. A missing or broken finger leaves small pans unstable over the flame. The feet or contact points underneath can also wear, letting the trivet slide around or scratch the stainless surface below it.

Part details

• Genuine Electrolux group part number 140182722011
• Thin cast trivet pan support
• For 60cm stainless steel gas cooktops
• Other trivet styles may not fit, so match the number

Fitting the trivet

Make sure all burners are off and cold. Lift the old trivet away and clean the stainless surface underneath with a soft cloth so grit doesn't scratch it. Lower the new trivet into position, checking it lines up with the burners and rests evenly. Test it with a small saucepan to make sure it doesn't rock.

Questions about this part

Do I need more than one trivet for a 60cm cooktop?

That depends on the cooktop layout. Some use one large support, others use two or more. Check the quantity shown against 140182722011 on your parts list, or send your model details and we'll tell you how many you need.