140180051066 Genuine Drain Pump 110-140V 50Hz 35W for Electrolux, AEG Dishwashers

Part 140180051066 is a genuine Electrolux drain pump rated at 110 to 140 volts, 50Hz and 35 watts. It is an Electrolux group dishwasher part of the type used in Electrolux and AEG machines. Because its voltage rating sits well below mains voltage, it only suits appliances built with a pump of the same rating. Check the number on your old pump reads 140180051066 before you order.

Dishwasher not draining? Signs the drain pump has failed

The drain pump sits in the sump under the tub and pushes used wash water out through the drain hose, both between rinses and at the end of the cycle. When it fails you usually find dirty water left sitting in the bottom of the dishwasher, a program that stops partway with an error code, or a humming or grinding noise with no water moving. Before replacing it, clean the filters and check the drain hose isn't kinked or blocked. A choked filter, or a chip of glass caught in the pump impeller, can give exactly the same symptoms.

Part details

• Genuine Electrolux part number 140180051066
• Rated 110-140V, 50Hz, 35W
• Drain pump for Electrolux group dishwashers
• Replace only with a pump of the same voltage rating

Changing the drain pump

Switch the dishwasher off at the wall and turn off the water tap before you start. Bail out any standing water and keep towels handy, as some always runs out when the pump comes off. Photograph the wiring plug and the way the pump locks into the sump, then fit the new one the same way. Run a short program and watch underneath for leaks.

Questions about this part

Can I connect this pump straight to 240V power?

No. Part 140180051066 is rated 110 to 140 volts at 35 watts. It should only go into an appliance built for a pump of that rating, connected exactly the way the original pump was. Never wire it directly to a 240V supply.