140115287058 Genuine Pressure Tube and Air Dome Assembly 715mm for Electrolux Group Washing Machines, Pressure Switch Hose

Genuine Electrolux group part 140115287058 combines the pressure tube and air dome in a single 715mm assembly. Together they carry the air pressure that tells the washer's pressure switch or level sensor how much water is in the tub. Electrolux doesn't give us a model list for this one, so match 140115287058 against the old part or check the model details on your rating plate before ordering.

Washing machine overfilling or not filling? Check the pressure tube

As water rises in the tub it traps air inside the air dome and pushes that air up the tube to the pressure switch or level sensor. The control reads that pressure as a water level and stops the fill at the right point. If the tube splits, comes loose, kinks or clogs with lint and detergent sludge, the reading goes wrong. Typical results are a washer that keeps filling or overflows, stops partway with a fill or level error, or won't start the wash because it thinks the tub is already full.

Part details

• Genuine Electrolux group part 140115287058
• Pressure tube with air dome, supplied as an assembly
• Tube length 715mm
• For washing machine water level sensing

Fitting the pressure tube assembly

Unplug the washer and turn off both taps. Note how the old tube is routed and clipped, because a kink or a dip that holds water will upset the level reading. Push the new tube fully onto the sensor spigot and fit the air dome in the same position. Don't blow into the pressure switch. Run a short rinse and watch that the machine fills to a normal level and stops.

Questions about this part

Can I use any hose instead of this assembly?

We'd advise against it. The tube length and the air dome both affect the pressure reaching the sensor, and the wrong setup can cause overfilling or level errors. The genuine 140115287058 assembly keeps the water level readings the way Electrolux designed them.