140055278018 Genuine Screw M4 x 0.7 x 25mm Torx TX20 Black for Electrolux Group Appliances

Lost or stripped a screw during a repair? Electrolux part 140055278018 is a genuine M4 screw with a 0.7mm thread pitch and a 25mm length, finished in black with a Torx TX20 drive. Fasteners like this are listed by number for each Electrolux group model, so check that your model's parts list shows 140055278018 before ordering. Matching the exact screw keeps panels, trims and handles sitting the way they should.

Why the exact screw matters

A screw looks like a small thing until the wrong one goes in. Too long and it can hit a wire, a seal or the inside of a panel. Too short and it won't hold, so a handle, trim or bracket works loose over time. The wrong thread will strip the hole it's driven into. This screw has an M4 metric thread at 0.7mm pitch and a 25mm length, with a Torx TX20 head that grips the driver well and is less likely to slip than a Phillips head. The black finish matches the original where the head is on show.

Part details

• Genuine Electrolux part 140055278018
• M4 metric thread, 0.7mm pitch
• 25mm length
• Torx TX20 drive
• Black finish

Tips for fitting the screw

Switch the appliance off at the wall before opening any panels. Use a proper TX20 Torx bit, as a near enough bit will chew the head. Start the screw by hand so it follows the existing thread, then snug it up without overtightening, especially into plastic. If the old hole is stripped, a new screw alone won't fix it.

Questions about this part

Will a hardware store M4 screw do the same job?

It might, but the length, head shape and finish all need to match. A screw that's too long can damage whatever sits behind the panel. Using 140055278018 takes out the guesswork when your parts list calls for it.