140014525368 Genuine Inverter Drive PCB for VESD9C Compressor, Electrolux Group Fridges, Variable Speed Compressor Controller

Electrolux group fridges with a VESD9C variable speed compressor use an inverter drive board to run it, and 140014525368 is the genuine Electrolux board for that compressor. The VESD9C is an Embraco compressor model, and the code is printed on the compressor's label. Drive boards are matched to particular compressors, so confirm the compressor code before ordering. No list of fridge models is on file.

Inverter board faults that stop a fridge cooling

The inverter board takes the run signal from the fridge's main control and converts mains power into the variable speed supply the compressor needs. If it fails, the compressor won't start even though the fridge lights and fans still work. Common signs are a fridge and freezer that both warm up, a compressor that tries to start then stops, clicking from the back, or a tripped safety switch. Power surges and heat are frequent causes. A compressor fault can look exactly the same, so have both tested before replacing either one.

Part details

• Genuine Electrolux part 140014525368
• Inverter drive board for VESD9C compressors
• For Electrolux group refrigerators
• Match the compressor code on its label

Fitting the inverter board

Unplug the fridge and leave it for several minutes so the board's capacitors can discharge. The board is usually mounted on or near the compressor at the back of the fridge. Photograph the connections, swap the board and make sure every plug is fully home. Power up and listen for the compressor starting. If you're not confident with electronics, get a qualified technician to do it.

Questions about this part

Where do I find the compressor code?

Pull the fridge out and look at the label on the compressor in the bottom rear compartment. It shows the compressor model. This board is for the VESD9C. If yours shows a different code, such as VESD7C or VESD11C, it needs a different board.