140004668087 Genuine Door Seal Bellows for AEG Front Load Washing Machines LF8C9412A LF8C9412AC LF8E8411A

Part 140004668087 is the genuine AEG door seal for front load washers, listed for the LF8C9412A, LF8C9412AC and LF8E8411A. If you can see a split in the folds, water is escaping at the front of the machine or the rubber is stained beyond cleaning, this is the matching bellows for those three models. Confirm the full model number before ordering, as AEG seals differ between machine families.

AEG washer leaking from the door?

This rubber bellows forms the watertight link between the drum opening and the front panel, and the door glass presses into it when the door is shut. Because it flexes with every wash and spin, small nicks from zips, hooks or coins can grow into tears. Perished rubber also loses its grip on the clamp bands. You'll typically notice water dripping from under the door, a wet floor after the cycle, or black mould spots that keep coming back in the folds. Leaving a torn seal in place lets water reach the motor and electronics underneath, so replace it early.

Part details

• Genuine AEG part 140004668087
• Front loader door seal bellows
• Listed for AEG LF8C9412A, LF8C9412AC and LF8E8411A

Replacing the AEG door seal

Power off at the wall and shut the taps first. Remove the outer wire band from the front lip of the seal, then take off the front panel to reach the inner band on the drum. Note any alignment marks on the seal and drum. Fit the new bellows at the drum first, secure both bands evenly and run a short wash with no load to check for drips.

Questions about this part

Where is the model number on my AEG washer?

Open the door and look around the rim of the opening for the rating label. It shows the model, such as LF8C9412A, plus a product number. Check the model against the three listed here before ordering.