1324416120 Genuine 2 Way Inlet Valve with Flowmeter for Electrolux, AEG Front Load Washing Machines EWF1083 EWF1282 EWF1282G EWF1481

Part 1324416120 is a genuine Electrolux 2 way solenoid inlet valve with a built-in flowmeter, used in Electrolux and AEG front load washers. You might find it under several other numbers, including 8581324416008, 132441612, 132441610 and 1324416005. It's listed for the Electrolux EWF1083, EWF1282, EWF1282G and EWF1481. Check it first when the machine shows a fill error or keeps running water into the drum.

Electrolux front loader not filling or flooding

This valve feeds water into the machine through two outlets, usually directing it to different sections of the detergent drawer so powder and softener are flushed at the right time. The flowmeter counts the water passing through, letting the control board measure the fill rather than rely only on a pressure switch. A coil failure stops one or both outlets, leaving detergent in the drawer or the drum empty. A faulty flowmeter can cause fill errors or overfilling, and a valve that won't close lets water trickle into the drum with the machine switched off.

Part details

• Genuine Electrolux part 1324416120
• 2 way solenoid valve with built-in flowmeter
• Alternative numbers 8581324416008, 132441612, 132441610, 1324416104, 1324416005 and 132441600
• Suits Electrolux EWF1083, EWF1282 and EWF1481 front loaders

Fitting the 2 way valve

Before anything else, pull the plug and close the tap. Unscrew the inlet hose, then lift off the top panel to reach the valve at the rear. Label the coil wires and the flowmeter connector, release the outlet hoses and undo the valve fixings. Fit the new valve, reconnect everything exactly as before, refit the top and open the tap slowly to check for leaks.

Questions about this part

Why are there so many numbers for this valve?

Electrolux has used several codes for this 2 way flowmeter valve over the years and across brands. 1324416120 and the numbers linked with it, such as 8581324416008 and 132441612, point to the same valve, so any of them on your old part leads here.